Roche Accu-Chek Active Manuel d'utilisateur télécharger pdf (Page 41)

Checking your meter

Read the package insert which

comes with the control solutions.

Take a test strip from the test

strip container. Close the

container again immediately.

Hold the test strip so that the

arrows printed on it and the

green square face upwards.

Gently slide the test strip into the

test strip guide in the direction of

the arrows until you feel it lock

into place.

The test strip must lie ﬂat on the

measurement window cover.

Carrying out a control test

The meter turns on and ﬁrst

performs a default display check

(approx. 2 seconds).

Check that all the segments of

the numeric display

(mg/dL

meter) or

(mmol/L meter) as

well as the unit of measurement

are displayed.

If segments are missing, please

contact your customer support

and service centre (see page 63).

mg/dL meter

mmol/L

meter

Following the display check, the

code number is displayed (689 is

just an example).

Check that this code number is

the same as the code number on

the label of the test strip

container.

If the numbers do not match,

even though the code chip in the

meter belongs to the test strip

container, please contact your

customer support and service

centre.

2 3

man_06658768001_01_EN.indb 39 04.04.2013 09:13:33

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Roche Accu-Chek Active Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Roche Accu-Chek Active