Roche ACCU-CHEK Inform II Manuel de l'opérateur télécharger pdf (Page 122)

Maintenance and Care

122

Cleaning the base unit

■ Unplug the base unit before cleaning.

■ Wipe the surfaces with a soft cloth slightly

dampened (not wet).

■ Avoid wiping the electrical connectors on the back

of the base unit.

■ Dry the base unit thoroughly after cleaning.

Visually verify that no solution is seen in the base

unit connectors at the completion of cleaning. If

cleaning fluid is allowed to collect in any connector,

severe damage can occur to the meter and the base

unit.

■ If using commercially available pre-moistened

cleaning cloths, squeeze off excess cleaning

solution or blot on a dry paper towel to remove any

excess cleaning solution before cleaning the

surface of the base unit.

■ If cleaning solution does get on the connectors or

pools in the base unit, unplug the base unit, then

dry the components with a dry cloth or gauze pad

before returning the meter to the base unit.

■ Plug in the base unit.

NOTICE

Ensure meter/base unit (including connectors) are thor-

oughly dried after cleaning or disinfecting. A flashing

LED (red) on the base unit indicates a fault condition.

NOTICE

Do not spray the base unit directly with solutions as this

could cause the solution to enter the case and damage

the electronic components.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 159 160

Pas de commentaire

Roche ACCU-CHEK Inform II Manuel de l'opérateur Page 122