Roche ACCU-CHEK Inform II Manuel de l'opérateur télécharger pdf (Page 101)

Initial Startup

101

5 Place the tapering end of the battery pack on the

small ledge of the opening and push down like a lid

to close (as shown in the illustration below). Make

sure that the plug connector wires slide into the

groove provided for them on the battery pack.

Gently pushing down the “lid” as described here

helps to align the wires properly so that they do not

get pinched or bent.

6 The battery pack should now t neatly inside the

meter. If this is not the case, check whether the

screws have been loosened enough or if the wires

are caught between the sides of the battery pack

and the meter.

7 Tighten both screws until snug (do not overtighten).

Until then, the cover will have some play due to the

inner gasket and the o-rings around the screws.

After you have tightened the screws, the cover

should be ush with the sides of the meter.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 191 192

Pas de commentaire

Roche ACCU-CHEK Inform II Manuel de l'opérateur Page 101