Roche ACCU-CHEK Inform II Manuel de l'opérateur télécharger pdf (Page 44)

Patient Glucose Testing

Conrming or selecting the test

strip lot

Once you have entered and conrmed the patient ID, you

are asked to choose the lot number for the test strips.

Compare the number displayed by the meter to the

number on the label of the test strip vial.

1 Select the lot number as follows:

n To read the lot number from the test strip vial via

barcode scanner, press and release

. Follow

the instructions for scanning IDs (see note below).

n To use the preselected lot number displayed by the

meter, touch

to conrm.

n To use a different lot number than the one

displayed, touch

to display a list of stored lot

numbers. Select the desired lot number from the

list.

2 Touch

to conrm the selected test strip lot

number.

The meter can be congured so that manual

conrmation is not necessary. In this setup, only the lot

number is displayed. Additional options are not

available.

The meter can be congured so that lot numbers are

entered via barcode scanner only (see note below).

For additional information about storing lot numbers for

test strips, see page 65.

Note: Barcodes on test strips vials/control solutions

may not be available in all countries. In this case either

n manually enter the lot number each time

(recommended),

n pick a previously entered lot number from the list,

n congure the meter to only display the lot number

(without conrmation by the operator).

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 191 192

Pas de commentaire

Roche ACCU-CHEK Inform II Manuel de l'opérateur Page 44